3GP E&I QC Advisor

• Establish and support proactive and collaborative working relationships with Project Teams and site Contractors. • Coordinate and influence Project Quality Teams with best practices and monitor the consistent application of the Project Quality Management System. • Work with a proactive approach to preventing quality issues through review and improvement. • Ensure Quality issues are effectively communicated with the respective Project Team and provide support to determine appropriate solutions. • Facilitate the consistent application of the structured Construction Quality Surveillance Programme. • Review Contractor deliverables against project requirements as and when required. • Evaluate and monitor the effectiveness of inspectors and identify training requirements to continually improve the performance of Quality Teams. • Participate in all initiatives related to Electrical Equipment in Hazardous Areas and ensure a common understanding and implementation throughout the projects. • Verify equipment is installed in correct area of classification. • Witness and verify that all testing procedures for grounding, megger, Hi-hot, point to point and calibration have been approved and are on site. • Provide QC support to all Project Teams and conduct surveillance/ witness testing in accordance with approved ITPs, as required. • Monitoring of electrical and instrumentation installation, above and below ground, junction boxes, cable tray installation, cable pulling, dressing of cable, glanding, labeling, terminations, tube bending and calibrations. • Monitor field E&I installation activities and ensure that negative trends are escalated and addressed appropriately.

• A degree in a relevant technical discipline is highly desirable, but not essential if the candidate can demonstrate the right level of technical and commercial experience. • COMPEX certificate or equivalent • HV/LV Switchgear & Protection • Transformers, Turbines/Generator • Variable Speed Drives (VSD/VFD) • HV/LV motors • Hazardous Area - ATEX • Working knowledge of looping checking, wiring continuity and color coding, start-up & troubleshooting • Confirm testing parameters are duly recorded and that testing equipment is calibrated • Single line, Block & schematic diagrams

Tengiz 28/28